AMP-D 15
AMP-D15 single-point needle nozzle structure technical characteristics
- Valve gate hot nozzle, driven valve needle sealing gate by mechanical means such as air pressure or oil pressure. The valve gate does not have a casting phenomenon, but only a very small circle is left on the surface of the product, which is suitable for a variety of surface -required products.
- Because the valve gate hot nozzle can open a larger gate, it can provide a higher injection rate and faster injection speed, so that the molded products have better performance, especially for a large number of sensitive agents The thermoplastics provide lower injection pressure and do not clog the gate easily.
- The general color change performance, and can adjust the opening time of different gates through timing control, and achieve higher product requirements.
- The AMP-D15 needle valve hot nozzle is applicable to the needle valve type glue in the same line of the main rubber inlet and the plastic inlet of the product. It is suitable for most plastic materials.